24 hour Emergency Number (ChemTrec®):
800-424-9300
Littleton,
CO 80128, USA
SECTION II - COMPOSITION/INFORMATION
ON INGREDIENTS
Chemical Name
CAS Number
%
TLV
PEL
Lightweight Aggerate (Mullite,
Anorthite)
None
50-70
10 mg/m3
None est.
Clay
1332-58-7
5-15
2 mg/m3
5 mg/m3
Perlite
93763-70-3
3-18
3 mg/m3
5 mg/m3
Calcium Aluminate Cement
Variable
20-40
3 mg/m3
5 mg/m3
Aluminum Oxide
1344-28-1
<4
3 mg/m3
5 mg/m3
Product dust contains:
Crystalline Silica (quartz)
14808-60-7
<6
0.05 mg/m3
0.1 mg/m3
Crystalline Silica (cristobalite)
14464-46-1
<15
0.05 mg/m3
0.05 mg/m3
Key:
TLV = ACGIH, 8 hr. time weighted average (TWA); PEL = OSHA
permissible exposure limit.
TLV and PEL limits are for total
respirable dust.
SECTION III - HAZARDS
IDENTIFICATION
Emergency Overview: This product contains crystalline silica which is considered a chronic health hazard by inhalation. The International Agency for Research on Cancer (IARC) has classified occupational exposures to respirable crystalline silica as being carcinogenic to humans (Class 1). This classification is based on what IARC considered sufficient evidence from epidemiological studies of humans for the carcinogenicity of inhaled silica in the forms of quartz and cristobalite. Crystalline silica is also known to cause Silicosis, a non-cancerous lung disease.
HMIS Rating:
Health: 1*
Fire: 0
Reactivity: 0
Other: 0
WHMIS Class:
D-2A - Material causing other toxic
effects (VERY TOXIC - Chronic)
Primary Routes of Entry: Via respirable dust to the lungs and respiratory
system and via coarse dust and particulate to the eyes.
Primary Target Organs: Lungs, respiratory system and eyes.
Potential Health Effects:
Inhalation: Long term overexposure to respirable crystalline silica
dust may cause permanent and irreversible lung damage including silicosis.
Skin Contact: Possible dryness or irritation resulting from long term exposures to product dust.
Eye Contact: A mechanical irritant which can cause moderate to severe eye irritation.
Ingestion: Non-hazardous when ingested. Potentially a mild Irritant to the GI tract if excessive quantity is ingested.
Medical Conditions Aggravated by Exposure: Pre-existing chronic upper respiratory and lung diseases such as, but not limited to, bronchitis, emphysema and asthma.
Carcinogenicity: This product contains crystalline silica which is classified as a class 1, human carcinogen by IARC, as a suspect carcinogen by NTP and as a possible select carcinogen by OSHA.
SECTION IV - FIRST AID
MEASURES
Inhalation: Remove to fresh air. Drink water to clear throat and blow nose to evacuate dust. If coughing and irritation develop, call a physician.
Eye Contact: Flush with large amounts of water until irritation subsides, as least 15 minutes. See a physician if irritation persists.
Skin Contact: Normal good personal hygiene practices. Wash with mild soap and warm water after each exposure.
Ingestion: Emergency procedures not normally required. May be a temporary irritant to the GI system.
SECTION V - FIREFIGHTING
MEASURES
NFPA Rating:
Health: 0
Fire: 0
Reactivity: 0
Other: 0
Flashpoint and Method: This
is a non-flammable product
LEL: N/Ap
UEL: N/Ap
Extinguishing Method:
Not applicable. Product will not burn.
Special Firefighting Procedures:
Not applicable.
Fire or explosion Hazards:
The cement products described above are non-flammable. However,
the paper packaging is combustible, and due care should be taken to minimize
fire hazards.
SECTION VI - ACCIDENTAL
RELEASE MEASURES
Clean-up Procedures: Shovel material into waste container taking care to minimize dust. Dampen if necessary to control dust. Vacuum clean dust with equipment fitted with HEPA filter
Personal Precautions: If dusty conditions exist, wear a face mask approved
for use with dusts such as 3M 8511 N-95 or equivalent.
SECTION VIII - EXPOSURE
CONTROLS/PERSONAL PROTECTION
Respiratory Protection:When over
PEL/TLV wear an approved face mask such as 3M 8511 N-95 or equivalent, to protect
against silica and pneumoconiosis producing dust. Concentrations of dust that
exceed the recommendations of the dust mask manufacturer will need a higher
level of respiratory protection, such as a half mask respirator with appropriate
dust filters.
Eye Protection: Wear safety glasses with side shields or goggles to protect eyes against dust and particulate when mixing dry cement.
Skin Protection: Under normal conditions the wearing of protective gloves and clean, body-covering clothing should be adequate.
Engineering Controls: Maintain sufficient mechanical or natural ventilation to assure dust concentrations remain below PEL/TLV. Use local exhaust if necessary. Power equipment should be equipped with properly designed dust collection devices.
SECTION IX - PHYSICAL
AND CHEMICAL PROPERTIES
Physical Form: Off white to gray granular powder.
No characteristic odor.
Melting Point: >2200*F
Specific Gravity: 0.9 to 1.5
Solubility in Water: Slight
Evaporation Rate: N/Ap
SECTION X - REACTIVITY
Stability: Product is stable under normal conditions.
Hazardous Polymerization: Cannot occur.
Incompatibilities: None in designed use.
Decomposition Products: None.
Conditions to Avoid: None in designed use.
SECTION XI - TOXICOLOGICAL/ECOLOGICAL
INFORMATION
LD50:
N/Av
LC50:
N/Av
Toxicological Hazards: No toxicological
studies of this specific product have been performed.
Ecological Hazards: Most ingredients in this product are naturally occurring minerals. Unless contaminated in service, this product is non-hazardous to the environment.
Teratogenicity, Mutagenicity, other Reproductive Effects: None known
SECTION XII - DISPOSAL
CONSIDERATIONS
Waste Disposal Method: May be disposed in an approved landfill unless contaminated in service. If contaminated with hazardous materials, place waste in suitable container. Seal and properly label the waste container. Send the container to an approved Transportation, Storage and Disposal (TSD) facility via an approved waste hauler. Be sure manifests have been completed and an adequate "Paper trail" has been established.
SECTION XIII - TRANSPORTATION
INFORMATION
US DOT Shipping Name: Not regulated
DOT Label: None
UN/NA Number: None
Canadian TGD Shipping Description:
Not regulated as dangerous goods according to Canadian TDGA
International Dangerous Goods Information:
IMO: Not regulated
as dangerous goods according to the IMDG Code.
ICAO: Not regulated
as dangerous goods according to the IACO Technical Instructions.
SECTION XIV - REGULATORY
INFORMATION
OSHA Status: This product is considered hazardous under OSHA criteria.
TSCA/CEPA Status: All components of this product are included in the
TSCA and CEPA Chemical Inventories.
CERCLA Reportable Quantity: N/Ap
SARA Title III:
Section 302 Extremely Hazardous: This product contains no extremely
hazardous substances as defined and listed in section #302
Section 311/312 Hazard Categories: Reportable as a hazardous substance.
Check with your Local Emergency Planning Committee for reportable quantities.
Section 313 Toxic Chemicals: This product does not contain substances
which are reportable under Section 313.
WHMIS Information: WHMIS Classification: D-2A - Material causing other
toxic effects (VERY TOXIC - Chronic). This product has been classified in accordance
with the hazard criteria of the Controlled Products Regulations (CPR).
Other Regulatory Classifications:
DSCL (EEC):
R36 - Irritating to eyes
R39 - Danger of very serious irreversible effects
R45 - May cause cancer
SECTION XV - APPROVALS
Reason for Issue: WHMIS 3 year update
Approval Date: June 4, 2006
Prepared by: CCG, Inc.
Supersedes Date:June 4, 2003
Revision History: Update HMIS Data, May 5, 2002; Change to
Crystalline Silica (quartz) TLV standard (0.05 mg/m3). Removal of Product
Stewardship Information (June 4, 2003).
SECTION XVI - DISCLAIMER
As of the date of this document, the foregoing information is believed to be
accurate and is provided in good faith to comply with applicable federal and
state laws. However, no warranty or representation of law or fact, with respect
to such information, is intended or given.
