MATERIAL SAFETY DATA SHEET

 

 

SECTION I - CHEMICAL PRODUCT AND COMPANY IDENTIFICATION

 

Trade Name:         ZelieBlok 2000S                                                                              MSDS Number:    BNZ-220

Generic Name:     Calcium Silicate Board                                                                                    Revision:    01

Manufacturer:     BNZ Materials, Inc.                                                                                   Date Issued:    April 8, 2007

Address:                6901 S. Pierce Street, Suite 260                                 24 Hour Emergency Number:    800-424-9300

                              Littleton, CO 80128, USA                                                                                               

 

       SECTION II - COMPOSITION/INFORMATION ON INGREDIENTS

 

Chemical Name                                                 CAS Number                       %                      ACGIH / TLV                  OSHA / PEL 

Synthetic Calcium Silicates                                         --                                94-98                          --                                    --

          Calcium Silicate                                         1344-95-2                             --                        10 mg/m3                              15 mg/m3

          Xonotlite                                                    12141-77-4                           --                         None                                       None

Natural Calcium Silicate                                        13983-17-0                        Proprietary              3 mg/m3                        5 mg/m3

Calcite                                                                 13397-26-7                        0-2                         10 mg/m3                      5 mg/m3

Cellulose Fiber                                                           --                                2-4                          None                            None

 

Key:   TLV = ACGIH, 8 hr. time weighted average (TWA);  PEL = OSHA permissible exposure limit.

          TLV and PEL limits are for respirable dust.

 

          SECTION III - HAZARDS IDENTIFICATION

 

Emergency Overview:  This product is non-hazardous under normal conditions of use.  Airborne particulate created during cutting and handling is considered nuisance dust and should be minimized through the use of good work practices and adequate ventilation. 

 

HMIS Rating:                Health:  1                 Fire:  0                 Physical Hazard:  0       Personal  Protection:  B

WHMIS Class:              Not regulated under WHMIS.

 

Primary Routes of Entry:  Via respirable dust to the lungs and respiratory system and via coarse dust and particulate to the eyes.

Primary Target Organs:  Lungs, respiratory system and eyes.

Potential Health Effects:

      Inhalation:  Irritating to the mucous membranes and respiratory tract.  Excessive exposures to dust may cause sore throat, coughing or upper respiratory irritation.

      Skin Contact:  Possible dryness or irritation resulting from long term exposures to product dust.   

      Eye Contact:  A mechanical irritant which can cause moderate to severe eye irritation.

 

 

          SECTION III - HAZARDS IDENTIFICATION

 

Potential Health Effects:

      Ingestion:  Non-hazardous when ingested.  Potentially a mild irritant to the GI tract if excessive quantity is ingested. 

Medical Conditions Aggravated by Exposure:  Pre-existing chronic upper respiratory and lung diseases such as, but not limited to, bronchitis, emphysema and asthma.

Carcinogenicity:  This product is not classified by IARC, NTP or OSHA.

 

          SECTION IV - FIRST AID MEASURES

 

Inhalation:  Remove to fresh air.  Drink water to clear throat and blow nose to evacuate dust.  If coughing and irritation develop, call a physician.

Eye Contact:  Flush with large amounts of water until irritation subsides, as least 15 minutes.  See a physician if irritation persists.

Skin Contact:  Normal good personal hygiene practices.  Wash with mild soap and warm water after each exposure. 

Ingestion:  Emergency procedures not normally required.  May be a temporary irritant to the GI system.

 

          SECTION V - FIREFIGHTING MEASURES

 

NFPA Rating:                Health:  0                     Fire:  0                   Reactivity:  0                            Other:  0

Flashpoint and Method:  This is a non-flammable product                           LEL:  N/Ap                           UEL:  N/Ap

Extinguishing Method  Not applicable.  Product will not burn.

Special Firefighting Procedures:  Not applicable.

Fire or explosion Hazards:  None

 

          SECTION VI - ACCIDENTAL RELEASE MEASURES

 

Clean-up Procedures:  Pick up or shovel material into waste container taking care to minimize dust.  Wet down if necessary to control dust.  Vacuum clean dust with equipment fitted with an efficient secondary filter

Personal Precautions:  If dusty conditions exist, wear a face mask approved for use with dusts such as 3M 8511 N-95 or equivalent.

Environmental Precautions:  None normally required.  Product contains naturally occurring minerals.

 

          SECTION VII - HANDLING AND STORAGE

 

Storage Requirements:  Store in dry area.  Always segregate materials by major hazard class.

Special Sensitivity or Incompatibility:   Avoid contact with strong acids.

Handling Precautions:  Assure proper respiratory protection if dust potential exceeds PEL/TLV.

 

          SECTION VIII - EXPOSURE CONTROLS/PERSONAL PROTECTION

 

Respiratory Protection:  When over PEL/TLV wear an approved face mask such as 3M 8511 N-95 or equivalent, to protect against dust. 

          SECTION VIII - EXPOSURE CONTROLS/PERSONAL PROTECTION

 

Eye Protection:  To protect eyes against dust and particulate, wear safety glasses with side shields or goggles when cutting material with mechanical equipment

Skin Protection:  Under normal conditions the wearing of protective gloves and clean, body-covering clothing should be adequate.

Engineering Controls:  Maintain sufficient mechanical or natural ventilation to assure dust concentrations remain below PEL/TLV.  Use local exhaust if necessary.  Power equipment should be equipped with properly designed dust collection devices.

 

SECTION IX - PHYSICAL AND CHEMICAL PROPERTIES

 

Physical Form:  Solid building boards                                            Odor:  No characteristic odor

Color:  Grey                                                                                          pH:  8

Melting Point:  2453° F (1345° C)                                                      Density @ 20° C (68° F):  245 kg/m3

Solubility in Water:  Insoluble                                                         Evaporation Rate:  Not applicable

 

SECTION X - REACTIVITY

 

Stability:  Product is stable under normal conditions.

Hazardous Polymerization:  Cannot occur.

Incompatibilities:  None in designed use.

Decomposition Products:  Decomposition of residual organic fillers will emit fumes of CO and CO2 during initial exposure to service temperatures.

Conditions to Avoid:  None in designed use.

 

SECTION XI - TOXICOLOGICAL/ECOLOGICAL INFORMATION

 

LD50:  N/Av                                                                          LC50:  N/Av

Toxicological Hazards:  No toxicological studies of this specific product have been performed.

Ecological Hazards:  Most ingredients in this product are naturally occurring minerals.  Unless contaminated in service, this product is non-hazardous to the environment. 

Teratogenicity, Mutagenicity, other Reproductive Effects:  None known

 

SECTION XII - DISPOSAL CONSIDERATIONS

 

Waste Disposal Method:  May be disposed in an approved landfill unless contaminated in service.  If contaminated with hazardous materials, place waste in suitable container.  Seal and properly label the waste container.  Send the container to an approved Transportation, Storage and Disposal (TSD) facility via an approved waste hauler.  Be sure manifests have been completed and an adequate "Paper trail" has been established.

 

SECTION XIII -  TRANSPORTATION INFORMATION

 

US DOT Shipping Name:  Not regulated                DOT Label:  None                               UN/NA Number:  None

 

SECTION XIII -  TRANSPORTATION INFORMATION

 

Canadian TGD Shipping Description:  Not regulated as dangerous goods according to Canadian TDGA

International Dangerous Goods Information:

          IMO:  Not regulated as dangerous goods according to the IMDG Code.

          ICAO:  Not regulated as dangerous goods according to the ICAO Technical Instructions.

 

SECTION XIV - REGULATORY INFORMATION

 

OSHA Status:  This product is considered hazardous under OSHA criteria.

TSCA/CEPA Status:  All components of this product are included in the TSCA and CEPA Chemical Inventories.

CERCLA Reportable Quantity:  N/Ap

SARA Title III:

          Section 302 Extremely Hazardous:  This product contains no extremely hazardous substances as defined and listed in section #302

          Section 311/312 Hazard Categories:  Reportable as a hazardous substance.  Check with your Local Emergency Planning Committee for reportable quantities.

          Section 313 Toxic Chemicals:  This product does not contain substances which are reportable under Section 313.

WHMIS Information:  Not controlled by WHMIS.

Other Regulatory Classifications:

DSCL (EEC):            None

 

SECTION XV - APPROVALS

 

Reason for Issue:    New MSDS.                                                                          Approval Date:      April 8, 2007

Prepared by:  CCG, Inc.                                                                                     Supersedes Date:      None

Revision History: None

 

SECTION XVI - DISCLAIMER

 

As of the date of this document, the foregoing information is believed to be accurate and is provided in good faith to comply with applicable federal and state laws.  However, no warranty or representation of law or fact, with respect to such information, is intended or given.