
![]() |
MATERIAL SAFETY DATA SHEET![]() |
![]() |
SECTION I - CHEMICAL PRODUCT
AND COMPANY IDENTIFICATION
Trade Name: Cement Fiber Seal,
High Temp. B MSDS
Number: B-012
Generic Name: Water repellent coating Revision: 3
Manufacturer: BNZ Materials, Inc. Date Issued: June 4, 2006
Address: 6901 S. Pierce Street, Suite 260 24 Hour Emergency Number: 800-424-9300
Littleton, CO 80128, USA
SECTION II - COMPOSITION/INFORMATION
ON INGREDIENTS
Chemical Name CAS
Number % ACGIH / TLV OSHA / PEL
Aliphatic petroleum
hydrocarbon 8052-41-3 50 525 mg/m3 2,900
mg/m3
Non-hazardous repellent
additive Proprietary 50 N/A N/A
SECTION III - HAZARDS
IDENTIFICATION
Emergency Overview: This product is an aliphatic paraffinic hydrocarbon and presents a minimal risk to health. Wash hands and exposed skin with soap and water after using this product. Exposure to vapors should be minimized through the use of good work practices and adequate ventilation.
HMIS Rating: Health: 1 Fire: 2 Physical Hazard: 0 Personal Protection: E
WHMIS Class: Not regulated under WHMIS.
Primary Routes of Entry: Via respirable vapors and mists to the lungs and respiratory system and via splashes to the eyes.
Primary Target Organs: Lungs, respiratory system and eyes.
Potential Health Effects:
Routes of Entry: Inhalation, skin contact, eye contact, ingestion
Inhalation: Overexposure to mist may cause transitory upper respiratory irritation.
Skin Contact: Essentially non-irritating to the skin.
Eye Contact: Mists may cause irritation to eyes.
Ingestion: Ingestion of large quantities may be irritating to the G.I. system.
Medical Conditions Aggravated by Exposure: May cause upper respiratory irritation, and may aggravate pre-existing respiratory conditions.
Carcinogenicity: This product is not classified by IARC, NTP or OSHA.
SECTION IV - FIRST AID MEASURES
Inhalation:
Move to an area free from risk of further exposure. Treat symptomatically if required. No adverse effects anticipated by this route of exposure
incidental to proper handling.
Eye Contact: Flush with copious quantities of clean, lukewarm water at low pressure for, at least, 15 minutes. Seek medical attention if irritation persists.
Skin Contact: Wash affected areas thoroughly with soap and warm water immediately after use of this product.
Ingestion: Ingestion of large quantities may be irritating to the GI tract, give two glasses of water and induce vomiting. Seek medical attention
SECTION V - FIREFIGHTING MEASURES
NFPA Rating: Health: 1 Fire: 3 Reactivity: 1 Other: 0
Flashpoint and Method: 115º F (TCC) LEL: Approx. 0.9 UEL: Approx. 6.0
Extinguishing Method Water, CO2, Dry chemical.
Special Firefighting Procedures: Wear self-contained breathing apparatus and protective clothing in fighting fire..
Fire or explosion Hazards: Moderate explosion hazard when exposed to flame. Will readily burn. Burning will emit oxides of carbon and silicone.
SECTION VI - ACCIDENTAL RELEASE MEASURES
Clean-up Procedures: Wipe up material and place into waste container.
Personal Precautions: Wear oil resistant gloves.
Environmental Precautions: Dike with absorbent boom to keep major spills from entering lakes and waterways.
SECTION VII - HANDLING AND STORAGE
Storage Requirements: Do not store near strong oxidizers. Always segregate materials by major hazard class.
Special Sensitivity or Incompatibility: Avoid contact with strong oxidizers.
Handling Precautions: Assure proper respiratory protection if vapor potential exceeds PEL/TLV.
SECTION VIII - EXPOSURE CONTROLS/PERSONAL PROTECTION
Respiratory Protection: When over PEL/TLV wear an approved face mask such as 3M 8271 N-95 or equivalent, to protect against organic vapors.
SECTION VIII - EXPOSURE CONTROLS/PERSONAL PROTECTION
Respiratory Protection: If misty conditions exist, wear a face mask approved for use with mists such as 3M 8271 N-95 or equivalent.
Eye Protection: Use safety glasses or goggles if there is potential for exposure to splashes or mists which could cause irritation of the eyes.
Skin Protection: Wear solvent resistant gloves.
Engineering Controls: Product is to be used with good mechanical or ambient ventilation.
SECTION IX - PHYSICAL AND CHEMICAL PROPERTIES
Physical Form: Water white liquid . Odor: Slight petroleum odor
Specific Gravity: Approx. 0.85 Boiling Point: <220º F
Vapor Density (air = 1): >1 pH: essentially neutral
Solubility in Water: Insoluble % Volatile by Volume (VOC): 50%
SECTION X - REACTIVITY
Stability: Product is stable under normal conditions.
Hazardous Polymerization: Cannot occur.
Incompatibilities: Strong oxidizers.
Decomposition Products: Decomposition of product will emit fumes of CO and CO2.
Conditions to Avoid: None in designed use.
SECTION XI - TOXICOLOGICAL/ECOLOGICAL INFORMATION
LD50: N/Av LC50: N/Av
Ecological Hazards: The water repellent nature of this product increases the longevity in the eco-system. Use care in handling this product to prevent ecological damage to the environment.
Teratogenicity, Mutagenicity, other Reproductive Effects: None known
SECTION XII - DISPOSAL CONSIDERATIONS
Waste Disposal Method: After the solvents have evaporated off, the residue may be disposed in an approved landfill unless contaminated in service. If the waste contains the petroleum solvent or if contaminated with hazardous materials, place waste in suitable container. Seal and properly label the waste container. Send the container to an approved Transportation, Storage and Disposal (TSD) facility via an approved waste hauler. Be sure manifests have been completed and an adequate "Paper trail" has been established.
SECTION XIII - TRANSPORTATION INFORMATION
US DOT Shipping Name: Naphtha DOT Label: Flammable liquid UN/NA Number: 1255
Canadian TGD Shipping Description: Not regulated as dangerous goods according to Canadian TDGA
International
Dangerous Goods Information:
IMO: Not regulated as dangerous goods according to the IMDG Code.
ICAO: Not regulated as dangerous goods according to the ICAO Technical Instructions.
SECTION XIV - REGULATORY
INFORMATION
OSHA Status: This product is considered hazardous under OSHA criteria.
TSCA/CEPA Status: All components of this product are included in the TSCA and CEPA Chemical Inventories.
SECTION XIV - REGULATORY
INFORMATION
CERCLA Reportable Quantity:
None
RCRA RQ: None
SARA Title III:
Section 302 Extremely Hazardous: This product contains no extremely hazardous substances as defined and listed in section #302
Section 311/312 Hazard Categories: Reportable as a hazardous substance. Check with your Local Emergency Planning Committee for reportable quantities.
Section 313 Toxic Chemicals: This product does not contain substances which are reportable under Section 313.
WHMIS Information: Not controlled by WHMIS.
Other Regulatory
Classifications:
DSCL (EEC): None
SECTION XV - APPROVALS
Reason for Issue: WHMIS 3 year update Approval Date: June 4, 2006
Prepared by: CCG, Inc. Supersedes Date: June 4, 2003
Revision History: Update HMIS Data, May 5, 2002; Removal of Product Stewardship Information. (June 4, 2003)
SECTION XVI - DISCLAIMER
As of the date of this document, the foregoing information is believed to be accurate and is provided in good faith to comply with applicable federal and state laws. However, no warranty or representation of law or fact, with respect to such information, is intended or given.